#1 General question - programming I/O Management Chips (ITE/ene/nuvoton...)
comasutra • 3 Липня 2017, 14:51
Hi there,
i'm not a newbe but never had such case before, so i'm unsure ... i have a pegatron VG20SQG-Board with burnt Richtek RT6575B. After removing and a closer look i think KBC-Controller (IT8587E) is defective, too (shorted +3V/GND). I have read somwhere, that these I/O-Controllers have to be programmed, so i can't use a new one without programming. Is this right? If yes...where can i get dump-files for specific mainboards?
Thanks in advance.
Boerge
i'm not a newbe but never had such case before, so i'm unsure ... i have a pegatron VG20SQG-Board with burnt Richtek RT6575B. After removing and a closer look i think KBC-Controller (IT8587E) is defective, too (shorted +3V/GND). I have read somwhere, that these I/O-Controllers have to be programmed, so i can't use a new one without programming. Is this right? If yes...where can i get dump-files for specific mainboards?
Thanks in advance.
Boerge