• Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

It is currently 14 December 2024, 10:29

 [SOLVED] Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

 Forum rules: Click here to view the forum rules

  1. Topic title should contain: the device's manufacturer, full model and the brief description of problem.
  2. Topic message should contain: the PCB marking code (required in case of hardware repairs), an extended description of problem, things you have checked/replaced/measured, your conclusions and the question. If you are not able to find the PCB marking code, please read THIS TOPIC. If you still cannot locate the PCB markings, please upload a clean, both-side photos of the mainboard - it is required to remove any films, modules or brackets possibly covering these markings.
  3. Before posting a new topic please read all topics in TRAININGS subforum and make a preliminary diagnostic based on the content of those trainings.
  4. Uploading of any complete schematics, BIOS / firmware files or any other kind of documentation, or linking to 3rd party websites with such files, is STRICTLY PROHIBITED. You can only upload the small portion of documentation or, link to BIOS file on UNVERIFIED BIOS FILES subforum, which simplifies the diagnostics/repair. You are not allowed to upload more then one complete page of instruction/schematic per single topic. The file you upload must not contain any watermarks, "confidential" markings, links or email addresses and cannot be password-protected.
  5. It is only permitted to describe one faulty device per single topic - you should always open a new topic for each subsequent device.
  6. Requesting of the full schematics, BoardView files, BIOS files or any other kind of documentation is NOT ALLOWED in this subforum. If you need to ask for any of these, you should open a new topic in DOCUMENTATION/BIOS REQUEST subforum.

#1 Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by arjuredi • 29 September 2022, 11:48
Witam.
Projektor po wystrzale lampy. Oznaczenia płyty głównej: 4H.1YU01.A01, poniżej zdjęcia:
Image
Image
Image
Image
Image
Po rozkręceniu wyczyściłem projektor ze szkła, zablokowana przez kawałki szkła była turbina chłodząca lampę. Na chwilę obecną projektor się włącza jednak nie daje napięcia na 2 nowe lampy, które podstawiałem i są sprawne w 100%. Ponieważ projektorów nie naprawiałem, proszę o pomoc od czego zacząć sprawdzenie?

Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by Google Adsense [BOT] • 29 September 2022, 11:48

#2 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by matic • 29 September 2022, 12:56
Hello!

Does the projector report any error (any LED is on or flashing except the blue power LED)?

#3 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by arjuredi • 30 September 2022, 08:43
No, 3 blue diodes lightning like normal working. I forgot to write, when the bulb exploded, the fuse in the box in the flat turned off.

#4 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by matic • 30 September 2022, 10:17
Measure the voltage between points A and B (not to ground, but between the points itself), when the projector is turned on.
Be aware of high voltage.
Image

#5 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by arjuredi • 1 October 2022, 10:55
0V

#6 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by matic • 2 October 2022, 12:10
Please, post a clear pictures of the power supply board from both sides.

#7 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by arjuredi • 10 October 2022, 10:55
Image

Image

#8 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by matic • 10 October 2022, 14:32
Check the transistor Q651.
If it's good, measure the voltages on all pins of this transistor in reference to the "hot" ground, when the projector is turned on.
The "hot" ground is the negative pole of the large (450V) capacitor near that transistor.
Be aware of high voltage.

#9 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by arjuredi • 14 October 2022, 12:27
I checked Q651 - it was damaged. Today I put on a new one and now I have 385V on legs A and B which were marked in the previous photo. The lamp is still off.

#10 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej  [SOLVED] 

by matic • 14 October 2022, 14:31
Check the listed components on the ballast board:
- All five power transistors (marked yellow).
- Power diode (marked red).
- Both coils (marked blue). As for the coils, it's enough to just check if they have a low resistance.
Image

#11 Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by arjuredi • 26 November 2022, 11:09
2 transistors on T4 and T5 (STP30NF20) were damaged, they just arrived and after the change the projector is alive. Thanks matic for your help.

Re: Projektor Acer H6510D - nie świeci nowa lampa po wybuchu starej

by Google Adsense [BOT] • 26 November 2022, 11:09
Similar Topics
  Lampa czołówka - nie ładuje akumulatora  [SOLVED]
Projektor Acer P1502 - martwy
Mactronic AHL0062 - latarka nie świeci
MSI MGP B550 Gaming Plus - płyta nie odpala, dioda CPU Debug ciągle świeci
  Lenovo 530S-14ARRI płyta NM-B781 stale świeci się dioda włącznika, nie startuje.  [SOLVED]
Subwoofer JBL SUB125 - nie uruchamia się, ciągle świeci dioda "standby"

Who is online

Users browsing this forum: No registered users and 0 guests

_______________________________
All rights reserved. Unauthorised copying of this website's content or any of its part is strictly forbidden.
Any trademarks, brand names, products or services published on this website belong to their legal owners, are copyrighted and used for information purposes only.