Forum rules: Click here to view the forum rules
- Topic title should contain: the device's manufacturer, full model and the brief description of problem.
- Topic message should contain: the PCB marking code (required in case of hardware repairs), an extended description of problem, things you have checked/replaced/measured, your conclusions and the question. If you are not able to find the PCB marking code, please read THIS TOPIC. If you still cannot locate the PCB markings, please upload a clean, both-side photos of the mainboard - it is required to remove any films, modules or brackets possibly covering these markings.
- Before posting a new topic please read all topics in TRAININGS subforum and make a preliminary diagnostic based on the content of those trainings.
- Uploading of any complete schematics, BIOS / firmware files or any other kind of documentation, or linking to 3rd party websites with such files, is STRICTLY PROHIBITED. You can only upload the small portion of documentation or, link to BIOS file on UNVERIFIED BIOS FILES subforum, which simplifies the diagnostics/repair. You are not allowed to upload more then one complete page of instruction/schematic per single topic. The file you upload must not contain any watermarks, "confidential" markings, links or email addresses and cannot be password-protected.
- It is only permitted to describe one faulty device per single topic - you should always open a new topic for each subsequent device.
- Requesting of the full schematics, BoardView files, BIOS files or any other kind of documentation is NOT ALLOWED in this subforum. If you need to ask for any of these, you should open a new topic in DOCUMENTATION/BIOS REQUEST subforum.
Re: Monitor Samsung 2494LW gaśnie po 3 sekundach
by Google Adsense [BOT] • 10 March 2023, 14:50
bazant82 wrote:Zaznaczone miejsca lutowania maja napięcie 0VWho asked you about the voltages on this solder joints?
I said the solder joints themselves are suspicious. Re-solder them with a soldering iron.
And DO NOT measure the voltages on these points again - these are a high voltage points, where the voltage can be several kV and it's very easy to damage your meter this way.
bazant82 wrote:Przelutowałem te punkty, rezystancja między punktami A,B oraz C,D nie zmieniła się.That's obvious, but does the monitor still turn itself off?
If so, the backlight CCFL lamps inside the matrix may be faulty. For the test connect any other approximately equal size matrix with the same backlight connectors (also make sure that the thick cables are at the same pins as on your original matrix) to the power supply board and connect the video LVDS cable to your old (original) matrix. Check whether the monitor still turn itself off in this case.
Who is online
Users browsing this forum: No registered users and 1 guest
_______________________________All rights reserved. Unauthorised copying of this website's content or any of its part is strictly forbidden.
Any trademarks, brand names, products or services published on this website belong to their legal owners, are copyrighted and used for information purposes only.